Carefully cut off the upright support with scissors or a razor blade & skip to step B.
Customers have also bent the upright and forced it down into the bin but we don’t recommend this method.
  

A) Remove the single large screw that holds the scooter’s front bag hook. Save the bolt.
You will not be reusing  the hook.

 

B) Match up the front curve of the GEN-U-BIN’s tray to the curve of the scooter’s open storage area.






View of fastener & screw from the underside

C) With the tray in place, push and hold the stainless screw and it’s fastener (nut)
towards the curve until it is under the scooter’s open storage bin lip.
Tighten the screw. Do not over-tighten.
Repeat on the 2^nd screw.





   

D) If you haven’t cut off the upright support, replace & tighten the center screw after inserting it into the hole.
Notice that it screws back in at a slightly upward angle.





  

E) While supporting the underside of the tray, push down around the rim of the drink holder to snap it into place.
Note: Remove the drink holder & just use the round opening for those larger/taller drink containers.

 
F) Position the bin in place and push down. The lid snaps closed.

You’re done!

Notice the slot on the right side?
It's there to secure a 2^nd holder -great for holding a fuel bottle on those long rural rides.
We recommend the Bell® Brand holder -available at most large dept. & drug stores.


2nd holder is not included.



NOTES:
Re-check the tightness of the screws occasionally.

Several objects can be stored underneath the tray – just pull up on the bin to retrieve the stored items.

®2009 Legend Creek LLC – All rights reserved